C4 CalibrateTool

CALIBRATE Tool

(available with the Calibrate or Complete license levels)
Updated Interface
Calibration Run
Like the VERIFY Tool, you have easy access to prior calibration sessions including subsetting into presses / customers / etc.
Calibration from a smaller initial target
For some printing systems a target smaller that the venerable P2P is sufficient for G7 calibration. Curve4 supports "miniP2P" and "microP2P" targets with as few as 96 patches.
Recalibration from a very small target
(only available with Complete license)
When re-calibrating a printing system that has already been successfully G7 calibrated, it's sometimes possible to use a very small target indeed. Curve4 supports Fast Re-Calibration using these targets (when it's appropriate for the printing system and pre-calibrated state)
Recalibration from a non-P2P target (P2P-less mode)
(only available with Complete license)
If you've only run an IT8, ECI2002 or other non-P2P target, Curve4 can generate the information it needs from the supplied patches. It may not have the same level of accuracy as that provided by a P2P target but for many printing systems it'll work just fine.
SCTV (Spot Color Tone Value) support
The Idealliance Print Properties group has determined that the Spot Color Tone Value method is the best for calibration of spot color inks. Curve4 fully supports this new method. (Curve3 used Percent ΔE to calculate calibration of special ink curves)
Ink Channel Limiting / Balanced Neutral Black
Ink Restriction Function
Up to now, Curve has never altered the 100% level of any ink channels. For offset printing, this is the recommended method. But wth inkjet printing, where the gamut tends to be larger and the mass tone effect can cause significant hue shifts as ink density increases, limiting ink channels can be useful. Gray balance works better when the 300% CMY patch is close to neutral. Curve4 helps bring that CMY combination under control, improving gray balance and tonality in the process.
PressSync Curves
Curve4 can output PressSync™ curve codes as well as accept them for initial curve values for those printing with Esko's curve specification method. We worked with Esko to ensure Curve4 uses this system properly.